This is a budget friendly Crankshaft for Vespa Piaggio Mopeds - 12 Pin
This will work with Vespa mopeds such as Ciao, Bravo, Grande, etc. Please refer to the pictures. Needle bearing is included with the crankshaft.
This is a 12 pin version. This is also available in a 10 pin version here. Be sure to get the correct one you need.
Related Products
Reviews
-
Points cam does not fit correctly and I can not time the motor correctly
The points cam does not fit on the motor without hammering it in place . I did and now it will be impossible to remove . The crank slot is in the wrong position to time the motor so basically you either have to time it with no woodruff key or the crank is trash . That means removing the engine again . Either case , this is not right . This crank is garbage . i wish that I had never purchased it . Bike is sitting awaiting another motor .
-
Points cam collar wont fit on this
Went in nice but but cant get my point cam collar down to where its suppose to sit. Inside diameter collar is 14.4, the base on the shaft where it suppose to sit is 14.4, it should be smaller. I don't know if they make a collar that fits this shaft. I'm going to have to sand the inside of mine of drill it out for it to work.